Filters: Tags: Republic of the Marshall Islands (X)5 results (6ms)
One Meter Topobathymetric Digital Elevation Model for Majuro Atoll, Republic of the Marshall Islands, 1944 to 2016
Located in the northern tropical Pacific Ocean, Majuro is the capital of the Republic of the Marshall Islands. Majuro Atoll consists of a large, narrow landmass and a set of smaller perimeter islands surrounding a lagoon that is over 100 square miles in size. The waters surrounding the Majuro Atoll land areas are relatively shallow with poorly mapped bathymetry. However, the Pacific Ocean on the exterior of the coral atoll and the lagoon within its interior consist of deep bathymetry with steep slopes. The highest elevation of the Majuro Atoll is estimated at only 3-meters above sea level, which is the island community of Laura located on the western part of the atoll. At the eastern edge of the atoll lies the capital...
Low-lying island environments, such as the Majuro Atoll in the Republic of the Marshall Islands, are particularly vulnerable to inundation (coastal flooding) whether the increased water levels are from episodic events (storm surge, wave run-up, king tides) or from chronic conditions (long term sea-level rise). Land elevation is the primary geophysical variable that determines exposure to inundation in coastal settings. Accordingly, coastal elevation data are a critical input for assessments of inundation exposure and vulnerability. Previous research has demonstrated that the quality of data used for elevation-based assessments must be well understood and applied to properly model potential impacts. The vertical...
Time series data of water surface elevation and wave height were acquired at ten locations for 517 days (in three separate deployments) off the north coast of Roi-Namur Island, Kwajalein Atoll, Marshall Islands, in support of a study on the coastal circulation patterns and the transformation of surface waves over the coral reefs. The relative placement of sensors on the reefs were as follows: ROI13W1 and ROI13E1 – fore reef ROI13W2 and ROI13E2 – outer reef flat ROI13W1 and ROI13E1 – middle reef flat ROI13W1 and ROI13E1 – inner reef flat
Time series data of water surface elevation and wave height were acquired at ten locations for 518 days (in three separate deployments) off the south coast of Kwajalein Island, Marshall Islands, in support of a study on the coastal circulation patterns and the transformation of surface waves over the coral reefs. The relative placement of sensors on the reefs were as follows: KWA13W1 and KWA13E1 – fore reef KWA13W2 and KWA13E2 – outer reef flat KWA13W1 and KWA13E1 – middle reef flat KWA13W1 and KWA13E1 – inner reef flat
Model parameter input files to compare wave-averaged versus wave-resolving XBeach coastal flooding models for coral reef-lined coasts
This data release includes the XBeach input data files used to evaluate the importance of explicitly modeling sea-swell waves for runup. This was examined using a 2D XBeach short wave-averaged (surfbeat, XB-SB) and a wave-resolving (non-hydrostatic, XB-NH) model of Roi-Namur Island on Kwajalein Atoll in the Republic of Marshall Islands. Results show that explicitly modelling the sea-swell component (using XB-NH) provides a better approximation of the observed runup than XB-SB (which only models the time-variation of the sea-swell wave height), despite good model performance of both models on reef flat water levels and wave heights. However, both models under-predict runup peaks. The difference between XB-SB and...